Datalogic Magellan 3450VSi - 2 D Double Read Timeout

2D Double Read Timeout Enter/Exit Programming Mode
Product Reference Guide 13
2D Double Read Timeout
The 2D Double Read Timeout feature specifies the minimum allowable time
which must pass before reading the same 2D label again (e.g. two identical
items in succession).
To set this feature:
1. Scan the Enter/Exit Progr
amming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
03DF1E(CR)
2D Double Read Timeout = 300ms
03DF28(CR)
2D Double Read Timeout = 400ms
03DF3C(CR)
2D Double Read Timeout = 600ms
DEFAULT
03DF46(CR)
2D Double Read Timeout = 700ms
03DF50(CR)
2D Double Read Timeout = 800ms
If the incidence of multiple reads is not acceptable, increase the
Timeout setting to a higher value.