Code 93 Length 2 Enter/Exit Programming Mode
Product Reference Guide
235
Code 93 Length 2
If Code 93 Length Control is set to Fixed-Length decoding, this feature speci-
fies Code 93 second fixed length. If Code 93 Length Control is set to Variable-
Le
ngth decoding, this feature specifies the maximum label length.
NOTE
When in Fixed Length mode, if Fi
xed Length 2 is set to the value of
00 (zero), then only Length 1 will apply.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code, Set Code 93 Length 2 on page 235 below. You’ll need
to cover any unused bar codes on this and the facing pag
e to ensure that
the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the desired l
abel length. The selectable range for this
option is 00 (meaning ignore this length), or 01 to 50. Pad all single digit
numbers with a leading zero to yield a two-digit entry (01-50).
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Set Code 93 Length 2
DEFAULT
Default setting for this feature = 32 (length = 50)
To Next Page
Loading...
