Enter/Exit Programming Mode Code 93 Stitching
236 Magellan™ 3450VSi
Code 93 Stitching
Enables/disables stitching for Code 93 labels. When parts of a Code 93 bar
code are presented to the scanner with this feature enabled, the bar code parts
will be assembled by the scanner’s software, and the data will be decoded if all
bar code proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Code 93 Stitching = Disable
Code 93 Stitching = Enable
To Next Page
Loading...
