Datalogic Magellan 3450VSi - MSI Number of Check Characters

MSI Number of Check Characters Enter/Exit Programming Mode
Product Reference Guide 239
MSI Number of Check Characters
Specifies number of MSI check characters to be calculated and verified.
NOTE
Check characters are always modulus 10.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code below representing
the desired number of MSI check
characters to be calculated and verified. You’ll need to cover any unused
bar codes on this and the facing page to ensure that the scanner reads
only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
021700(CR)
MSI Number of Check Characters = 1
021701(CR)
MSI Number of Check Characters = 2