Datalogic Magellan 3450VSi - Standard 2 of 5 Check Character Transmission

Standard 2 of 5 Check Character Transmission Enter/Exit Programming Mode
Product Reference Guide 249
Standard 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Standard 2 of 5 check character.
NOTE
This feature applies only when
Standard 2 of 5 Check Char-
acter Calculation on page 248 is enabled. This item is
ignored when the advanced feature, Full Label Edit, is enabled.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
049B00(CR)
Standard 2 of 5 Check Character Transmission = Disable
049B01(CR)
Standard 2 of 5 Check Character Transmission = Enable
DEFAULT