Micro QR Code Length Control Enter/Exit Programming Mode
Product Reference Guide
277
Micro QR Code Length 1, Length 2 Programming Instructions
If Micro QR Code Length Control is set to Fixed-Length decoding, this feature
specifies Micro QR Code first fixed length. If Micro QR Code Length Control is
set to Variable-Length decoding, this feature specifies the minimum label
length.
NOTE
Length 1 is the minimum label len
gth if in variable length
mode, or the first fixed length if in fixed length mode. Length 2
is the maximum label length if in variable length mode, or the
second fixed length if in fixed length mode. Length includes
the bar code's data characters only. Any value > 3700 will be
considered to be 3700.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code, Set Aztec Length 1 on page 280 or Set Micro QR Code
Length 2 on page 277 below. You’ll need to cover any unused bar codes
on this and the facing page to ensure that the scanner reads only the bar
co
de you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the desired l
abel length. The selectable range for this
option is 0001 to 3700. Pad all numbers with leading zeros to yield a four-
digit entry (0001-3700).
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Default setting for this feature = 0001
Set Micro QR Code Length 1
Set Micro QR Code Length 2
Default setting for this feature = 0E74
To Next Page
Loading...
