2D Inverse Read Control Enter/Exit Programming Mode
Product Reference Guide 19
2D Inverse Read Control
This configuration item is used to toggle inverted label reading for 2D bar
codes, for example, a label printed as white on black as opposed to black on
white.
To set this feature:
1. Scan the Enter/Exit Progr
amming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
DEFAULT
2D Read Control = Disable
2D Read Control = Enable
To Next Page
Loading...
