Datalogic Magellan 3450VSi - Illumination During Disable Mode

Enter/Exit Programming Mode Illumination During Disable Mode
20 Magellan™ 3450VSi
Illumination During Disable Mode
This feature allows illumination to be turned off when the scanner is in “disable”
mode. It determines if the imager illumination is controlled by host interface
enable/disable commands.
Disable
= Illumination is not controlled by host enable/disable commands,
illumination stays on when disabled.
Enable =
Illumination is controlled by host enable/disable commands, illu-
mination is on when enabled and off when disabled.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your selection from the bar
codes below.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
063A00(CR)
Illumination During Disable Mode = Disable
063A01(CR)
Illumination During Disable Mode = Enable
DEFAULT