Datalogic Magellan 3450VSi - Reading Illumination Duration

Enter/Exit Programming Mode Reading Illumination Duration
22 Magellan™ 3450VSi
Reading Illumination Duration
This feature specifies how long the illumination stays on after a label or label segment is
read.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
04EB14(CR)
Reading Illumination Duration = 1 Seconds
04EB3C(CR)
Reading Illumination Duration = 3 Seconds
DEFAULT
04EB64(CR)
Reading Illumination Duration = 5 Seconds