Product Reference Guide 319
Appendix F
Host Commands
Accepting RS-232 Commands
The scanner responds to the following RS-232 commands:
COMMAND ASCII HEX COMMENT
Enable Scanner
E 0x45
Disable
Scanner
D 0x44
Reset Scanner
R 0x52
Not On File
Indication
F 0x46 Long series of beeps
Beep Good Read Tone
B 0x42 Beeps if Good Read Beep is enabled
Force Good Read Tone
! 0x01 Beeps regardless of beep setting
Identification request
i 0x69
Returns long response
a
a. Call Tech Support for information.
Health request
h 0x68
Returns long response
a
Status request
s 0x73
Returns long response
a
If one of the above commands is received, the scanner will perform the steps
indicated for the command. Host commands for other interfaces are also avail-
able. Contact Tech Support for more details.
Also see the section "Image Capture to the Host by Host Command" on
page 90
for details concerning that feature.
To Next Page
Loading...
