Enter/Exit Programming Mode Good Read LED Idle State
26 Magellan™ 3450VSi
Good Read LED Idle State
This feature specifies the state of the green scanner LEDs when the scanner is
idle and ready to read a label. Options are:
•Off
•On dim
To set the Scanner LEDs Idle State:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
Scanner LED Idle State = Off
Scanner LED Idle State = On Dim
To Next Page
Loading...
