Datalogic Magellan 3450VSi - Scanner Control Button Options

Scanner Control Button Options Enter/Exit Programming Mode
Product Reference Guide 27
Scanner Control Button Options
Configure the Scanner Control Button to one of the following modes of opera-
tion:
• Enable all functions: Volume, tone, diagnostics and reset.
• Enable only volume, tone and reset.
• Enable reset only.
• Disable all button functions
To set the desired Scanner Control Button Option:
1. Scan the Enter/Exit Progr
amming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
05AF00(CR)
Scanner Control Button = Enable All Functions
05AF01(CR)
Scanner Control Button = Enable Only Volume Tone and Reset
DEFAULT
05AF02(CR)
Scanner Control Button = Enable Reset Only
05AF03(CR)
Scanner Control Button = Disable All Functions