Enter/Exit Programming Mode Good Read Beep Control
28 Magellan™ 3450VSi
Good Read Beep Control
This feature enables/disables scanner beep upon successfully decoding of a
label.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
Good Read Beep Control = Disable
Good Read Beep Control = Enable
To Next Page
Loading...
