Datalogic Magellan 3450VSi - How to Capture an Image

Enter/Exit Programming Mode How to Capture an Image
36 Magellan™ 3450VSi
Imaging Features
How to Capture an Image
There are two methods of capturing images as discussed below:
• Image Capture to a microSD Card by Sca
nning a Special Label on page 36
• Image Capture to the Host by Host Command on page 37
Image Capture to a microSD Card by Scanning a Special Label
Insert a valid microSD card into the scanner (contact technical support if
needed). Scan a capture label and place the item to be captured in front of the
scanner. Press and release the Camera Button. The image will be written to the
microSD card five seconds after button release. See microSD Card on page 325
for more information.
The format, size, contrast, brightness and compression use the configured val-
ues.
This Capture label is as follows:
<FNC3>IMAGEFAUTO<CR>
NOTE
The Capture label will not read unless a microSD card is inserted.
The image filename is automatically increased from image000 to image999.
The date image file generated is not actual, since no real time clock is embed-
ded in the scanner.