Datalogic Magellan 3450VSi - Image Capture to the Host by Camera Button

Enter/Exit Programming Mode Image Capture to the Host by Camera Button
38 Magellan™ 3450VSi
Image Capture to the Host by Camera Button
Perform the following steps to set up the Camera Button.
1. Set the Camera Button Mode to enabled.
2. Set the Image Capture desti
nation to host port.
3. Press the camera button.
Scanner will beep for a few seconds, then take picture and send the Image
R
etrieval Event label to the POS to indicate image is ready. The data content of
the event label is:
A856102000239
The POS sends the picture retrieval command to initiate picture download from
the scanner. Format of the command is:
P\x02pG
The scanner sends the picture to the POS with the transmission format
described in the previous section, “Image Capture By Host Command”.
Camera Button Mode
This feature enables or disables the camera button.
DEFAULT
05B000(CR)
Camera Button Mode = Disabled
05B001(CR)
Camera Button Mode = Enable