Interface Type
56 Magellan™ 3450VSi
INTERFACE SELECTION
Interface Type
Specifies the current scanner interface. To access a scanner’s interface identifi-
cation number, place the scanner in Scanner Diagnostic Mode and view the 7-
segment FRU
display (reference Chapter 2, Scale Diagnostic Mode, for more
information).
NOTE
The correct interface cable is generally inc
luded for the reader interface
type you ordered.
Selections are:
INTERFACE (I/F)
TYPE
I/F I.D.
NUMBER
RS-232 Standard
05
RS-232 Wincor-Nixdorf
12
RS-232 Single Cable
20
USB OEM
45
USB Keyboard
35
USB-TEC
0D
USB COM
47
NOTE
CAUTION
NOTE
When an interface is selected, the scanner loads the configura-
tion for that interface as the selection is made. Any custom
configurations done in the
previous interface will not be carried
over to the configuration for the new interface.
Great care should be taken to select the correct interface type,
sinc
e you can cause damage to the scanner and/or POS termi-
nal by attempting to change t
o an incompatible interface.
ALWAYS make interface selections with the host cable DIS-
CONNECTED.
If the scanner’s interface type mus
t be changed, always be sure
that interface configuration is the FIRST item scanned during a
programming session. (Selecting an interface type resets ALL
other configuration items to the factory default for that inter-
face type.)
USB KEYBOARD FEATURES starting on page 88
•Keyboard Layout on page 88
•USB Keyboard Country Mode on page 88
•USB Keyboard Caps Lock State on page 91
•No Keyboard Support on page 92
•USB Keyboard Send Control Characters on page 93
•Quiet Interval on page 94
•USB Keyboard Intercharacter Delay on page 95
To Next Page
Loading...
