Enter/Exit Programming Mode RS-232 ACK NAK Features
70 Magellan™ 3450VSi
RS-232 ACK Character
This feature specifies which ASCII character will be used as an ACK character.
NOTE
DO NOT set this feature to use previously defined char-
acters such as XON, XOFF or host commands as this will
conflict
with normal operation of these characters. 8-bit
data is not recognized when the feature, RS-232 Num-
ber of Data Bits, is set to 7 data bits.
To specify the RS-232 ACK Character:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan the bar code, SET RS-232 ACK Char
acter below. You’ll need to cover
any unused bar codes on this and the facing page to ensure the scanner
reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the hex designation for the
desired character. A table con-
taining the ASCII Characte
r Set and their corresponding Hex Values is
available in the inside back cover of this manual. ASCII parameters must be
input by scanning a pair of hexadecimal digits for the desired character.
For example, if ASCII “A” were the desired ACK character, you would scan
the digits “4”, then “1” (the ASCII corresponding hex value).
4. The scanner will automatically exit Programming Mode when the appro-
priate amount of digits/characters
have been scanned.
Set RS-232 ACK Character
DEFAULT
Default setting for this feature is:
06
To Next Page
Loading...
