Cleaning
QUICK REFERENCE GUIDE 15
Manufacturer Approved Cleaning Materials
Datalogic recommends the use of the following cleaners on its products.
Under no circumstances should abrasive cleansers, abrasive pads,
caustic solutions or other harsh chemicals, including those listed below,
be used on any part of the scanner as they can cause damage which will
adversely affect scanning performance. Use of such materials, either
alone or in combination with other cleaning agents, will void the
manufacturer's warranty.
APPROVED CLEANERS
• Hydrogen Peroxide (not to exceed a 3% solution)
• Chlorine bleach (not to exceed a 0.25% solution)
• Mild detergent and water
• lsopropyl Alcohol (not to exceed a 70% solution)
CAUTION: Use of above cleaners
in combination with each
other
is not recommended and may constitute a health
hazard. Follow all specified safety precautions when using
any cleaning solution.
!!DO NOT USE!!
• Ammonia solutions • Trichloroethylene
• Acetone • Toluene
• Benzene • Carbolic acid
• Ethanolamine • Aromatic or chlorinated hydrocarbons
• Ethers • Aqueous or alcoholic alkaline solutions
• Ketones
To Next Page
Loading...
