Datalogic MAGELLAN 900i - Global MID-Label ID

ENTER/EXIT PROGRAMMING MODE
98 MAGELLAN™ 900I
Global Mid-Label ID
This feature specifies a global mid-label ID that is added between two barcodes for trans-
mission.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode “Set Global Mid-Label ID” below. You’ll need to cover any unused
barcodes on this and the facing page to ensure the scanner reads only the barcode
you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypad in
Appendix Appendix C
that represent the desired mid-label ID characters; entered as two hex pairs. A table
containing the ASCII Character Set and their corresponding Hex Values is available in
the inside back cover of this manual. ASCII parameters must be input by scanning a
pair of hexadecimal digits for each character. Thus, to set a two-character value of AB,
barcodes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. The selectable
range for this option is any hex value from 00 to FF.
Complete the programming sequence by scanning the Enter/Exit Programming Mode bar-
code.
Set Global Mid-Label ID
Default Label ID for this symbology is:
00 = No Global Mid-label ID
04C7(CR)
DEFAULT