Datalogic MAGELLAN 900i - Case Conversion

CASE CONVERSION ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 99
CASE CONVERSION
This option can change the case of all alphabetic characters in scanned barcode data to
upper or lower case.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan barcode for the desired option below. You’ll need to cover any unused barcodes
on this and the facing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
Case conversion affects ONLY scanned barcode data, and does not affect
Label ID, Prefix, Suffix, or other appended data.
Case Conversion = No Case Conversion
Case Conversion = Upper Case
Case Conversion = Lower Case
DEFAULT
033100(CR)
033101(CR)
033102(CR)