Datalogic MAGELLAN 900i - Coupon Control; Coupon Control Enable

ENTER/EXIT PROGRAMMING MODE
102 MAGELLAN™ 900I
COUPON CONTROL
Coupon Control Enable
This feature is used to control the method of processing coupon labels. For the purposes of
this feature, coupon labels are defined as:
1. UPC-A labels that start with a ‘5’
2. GS1 DataBar Expanded labels that start with ‘8110’
Enable UPC-A Coupons : UPCA coupon labels will decode but RSS/Databar Expanded cou-
pon labels will not. RSS/Databar Expanded labels that are not coupon labels will decode
and all UPCA labels will decode.
Enable GS1 DataBar Expanded Coupons : •RSS/Databar Expanded coupon labels will
decode but UPCA coupon labels will not. UPCA labels that are not coupon labels and
all RSS/Databar Expanded labels will decode.
Priority to UPC-A Coupons: UPCA coupon labels will be given priority.
Priority to GS1 DataBar Expanded Coupons : Databar coupon labels will be given prior-
ity.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your choice from the Coupon Control selections below. You’ll need to cover any
unused barcodes on this and the facing page to ensure that the scanner reads only
the barcode you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Coupon Control = Disable
Coupon Control = Enable UPC-A Coupons
03B900(CR)
03B901(CR)