Datalogic MAGELLAN 900i - Coupon Label Priority Timer

ENTER/EXIT PROGRAMMING MODE
104 MAGELLAN™ 900I
Coupon Label Priority Timer
This feature sets the duration of the UPCA / DataBar coupon label priority timer.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Coupon Label Priority Timer = 0.1 Seconds
Coupon Label Priority Timer = 0.2 Seconds
Coupon Label Priority Timer = 0.3 Seconds
Coupon Label Priority Timer = 0.4 Seconds
Coupon Label Priority Timer = 0.5 Second
Coupon Label Priority Timer = 1 Second
037F0A(CR)
037F14(CR)
DEFAULT
037F1E(CR)
037F28CR)
037F32(CR)
037F64CR)