UPC-A ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
105
UPC-A
UPC-A Enable
Enables/disables the ability of the scanner to decode UPC-A labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
UPC-A = Disable
UPC-A = Enable
02D000(CR)
02D001(CR)
To Next Page
Loading...
