ENTER/EXIT PROGRAMMING MODE
108
MAGELLAN™ 900I
UPC-A Minimum Read
This feature specifies the minimum number of consecutive UPC-A decodes before is
accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
UPC-A Minimum Read = 1
UPC-A Minimum Read = 2
UPC-A Minimum Read = 3
UPC-A Minimum Read = 4
DEFAULT
006101(CR)
006102(CR)
006103(CR)
006104(CR)
To Next Page
Loading...
