UPC-E ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
111
UPC-E Number System Character Transmission
Enables/disables transmission of a UPC-E number system character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
UPC-E Number System Character Transmission = Dis-
able
UPC-E Number System Character Transmission =
Enable
024800(CR)
024801(CR)
To Next Page
Loading...
