UPC-E ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
113
Expand UPC-E to UPC-A
Enables/disables expansion of UPC-E labels to UPC-A.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Expand UPC-E to UPC-A = Disable
Expand UPC-E to UPC-A = Enable
DEFAULT
004100(CR)
004101(CR)
To Next Page
Loading...
