ENTER/EXIT PROGRAMMING MODE
114
MAGELLAN™ 900I
Expand UPC-E to EAN-13
Enables/disables expansion of UPC-E labels to EAN/JAN-13.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Expand UPC-E to EAN-13 = Disable
Expand UPC-E to EAN-13 = Enable
DEFAULT
040200(CR)
040201(CR)
To Next Page
Loading...
