UPC-E ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
115
UPC-E Minimum Read
This feature specifies the minimum number of consecutive UPC-E decodes before is
accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
UPC-E Minimum Read = 1
UPC-E Minimum Read = 2
UPC-E Minimum Read = 3
UPC-E Minimum Read = 4
DEFAULT
006201(CR)
006202(CR)
006203(CR)
006204(CR)
To Next Page
Loading...
