ENTER/EXIT PROGRAMMING MODE
116
MAGELLAN™ 900I
EAN-13
EAN-13 Enable
Enables/disables the ability of the scanner to decode EAN/JAN-13 labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
EAN-13 = Disable
EAN-13 = Enable
02D300(CR)
02D301(CR)
To Next Page
Loading...
