EAN-8 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
121
EAN-8
EAN-8 Enable
Enables/disables the ability of the scanner to decode EAN/JAN-8 labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
EAN-8 = Disable
EAN-8 = Enable
02D200(CR)
02D201(CR)
To Next Page
Loading...
