ENTER/EXIT PROGRAMMING MODE
124
MAGELLAN™ 900I
EAN-8 Minimum Read
This feature specifies the minimum number of consecutive EAN-8 decodes before is
accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
EAN-8 Minimum Read = 1
EAN-8 Minimum Read = 2
EAN-8 Minimum Read = 3
EAN-8 Minimum Read = 4
DEFAULT
006501(CR)
006502(CR)
006503(CR)
006504(CR)
To Next Page
Loading...
