EAN-8 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
125
EAN-8 Guard Insertion
This setting enables the insertion of either a missing leading or trailing guard to a scanned
barcode.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
EAN-8 Guard Insertion = Disable
EAN-8 Guard Insertion = Enable
DEFAULT
054300(CR)
054301(CR)
To Next Page
Loading...
