ENTER/EXIT PROGRAMMING MODE
126
MAGELLAN™ 900I
EAN-8 Guard Substitution
This setting enables the scanner to substitute a guard pattern for even-parity 6 for EAN8/
JAN8 labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
EAN-8 Guard Insertion = Disable
EAN-8 Guard Insertion = Enable
DEFAULT
02FB00(CR)
02FB01(CR)
To Next Page
Loading...
