Datalogic MAGELLAN 900i - UPC;EAN Correlation

ENTER/EXIT PROGRAMMING MODE
132 MAGELLAN™ 900I
UPC/EAN Correlation
Enables/disables character correlation for UPC/EAN.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
UPC/EAN Correlation = Disable
UPC/EAN Correlation = Enable
DEFAULT
050700(CR)
050701(CR)