UPC/EAN GUARD INSERTION
PRODUCT REFERENCE GUIDE
133
UPC/EAN Guard Insertion
This setting enables the insertion of either a missing leading or trailing guard to a scanned
barcode.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
UPC/EAN Guard Insertion = Disable
UPC/EAN Guard Insertion = Enable
DEFAULT
054000(CR)
054001(CR)
To Next Page
Loading...
