ENTER/EXIT PROGRAMMING MODE
140
MAGELLAN™ 900I
Enable EAN Two Label
Enables/disables the ability of the scanner to decode EAN two-label pairs.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
Contact Customer Support for details about advanced program-
ming for this feature.
EAN Two Label = Disable
EAN Two Label = Enable
DEFAULT
004400(CR)
004401(CR)
To Next Page
Loading...
