OTHER UPC/EAN OPTIONS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
141
EAN Two Label Minimum Read
This feature specifies the minimum number of consecutive EAN Two Label decodes before
is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
EAN Two Label Minimum Read = 1
EAN Two Label Minimum Read = 2
EAN Two Label Minimum Read = 3
EAN Two Label Minimum Read = 4
DEFAULT
008601(CR)
008602(CR)
008603(CR)
008604(CR)
To Next Page
Loading...
