ENTER/EXIT PROGRAMMING MODE
142
MAGELLAN™ 900I
EAN Two Label Combined Transmission
Enables/disables the transmitting of an EAN two label pair as one label.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
EAN Two Label Combined Transmission = Disable
EAN Two Label Combined Transmission = Enable
DEFAULT
02E200(CR)
02E201(CR)
To Next Page
Loading...
