Datalogic MAGELLAN 900i - P2 Add-On Minimum Read

ENTER/EXIT PROGRAMMING MODE
144 MAGELLAN™ 900I
P2 Add-on Minimum Read
This feature specifies the minimum number of times a P2 add-on must decode before it is
marked valid.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode representing the desired option on this and the following page.
You’ll need to cover any unused barcodes on facing pages to ensure that the scanner
reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
P2 Add-on Minimum Read = 2
P2 Add-on Minimum Read = 3
P2 Add-on Minimum Read = 4
P2 Add-on Minimum Read = 5
P2 Add-on Minimum Read = 6
DEFAULT
005F02(CR)
005F03(CR)
005F04(CR)
005F05(CR)
005F06(CR)