GTIN ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
151
GTIN
GTIN Enable
Enables/Disables the ability to convert UPCE, UPCA, EAN8, and EAN13 labels into the GTIN
14-character format.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
If add-on information is present on the base label prior to the
conversion taking place, the add-on information will be appended
to the converted GTIN barcode.
GTIN = Disable
GTIN = Enable
DEFAULT
051500(CR)
051501(CR)
To Next Page
Loading...
