ENTER/EXIT PROGRAMMING MODE
152
MAGELLAN™ 900I
GS1 DATABAR
The symbology family GS1 DataBar™ was formerly known as Reduced Space Symbology
(RSS). For the purpose of simplicity, GS1 DataBar variants are listed in this manual as
“DataBar.”
DATABAR OMNIDIRECTIONAL
DataBar Omnidirectional Enable
Enables/disables the ability of the scanner to decode DataBar Omnidirectional labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This value-added feature is a factory-programmed option. Con-
tact your dealer for information about upgrading your system to
include this advanced capability.
DataBar Omnidirectional = Disable
DataBar Omnidirectional = Enable
DEFAULT
04D000(CR)
04D001(CR)
To Next Page
Loading...
