DATABAR OMNIDIRECTIONAL ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
153
DataBar Omnidirectional/EAN-128 Emulation
Enables/disables the ability of DataBar Omnidirectional to be transmitted as EAN-128.
1. To set this feature:
2. Scan the Enter/Exit Programming Mode barcode at the top of the page.
3. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
DataBar Omnidirectional/EAN-128 Emulation =
Disable
DataBar Omnidirectional/EAN-128 Emulation = Enable
DEFAULT
04D400(CR)
04D401(CR)
To Next Page
Loading...
