Datalogic MAGELLAN 900i - Databar Omnidirectional Minimum Read

DATABAR OMNIDIRECTIONAL ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 155
DataBar Omnidirectional Minimum Read
This feature specifies the minimum number of consecutive DataBar Omnidirectional
decodes before is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
DataBar Omnidirectional Minimum Read = 1
DataBar Omnidirectional Minimum Read = 2
DataBar Omnidirectional Minimum Read = 3
DataBar Omnidirectional Minimum Read = 4
DEFAULT
04D201(CR)
04D202(CR)
04D203(CR)
04D204(CR)