Datalogic MAGELLAN 900i - Databar Omnidirectional Double Read Timeout

ENTER/EXIT PROGRAMMING MODE
156 MAGELLAN™ 900I
DataBar Omnidirectional Double Read Timeout
Specifies the minimum allowable time which must pass before reading the same DataBar Omnidi-
rectional label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming Mode bar-
code.
DataBar Omnidirectional Double Read
Timeout = 0.5 Seconds
DataBar Omnidirectional Double Read
Timeout = 1 Second
DataBar Omnidirectional Double Read
Timeout = 2.5 Seconds
DataBar Omnidirectional Double Read
Timeout = 3 Seconds
DataBar Omnidirectional Double Read
Timeout = 3.5 Seconds
00510A(CR)
005114(CR)
DEFAULT
005132(CR)
00513C(CR)
005146(CR)