DATABAR LIMITED ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
157
DATABAR LIMITED
DataBar Limited Enable
Enables/disables the ability of the scanner to decode DataBar Limited labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Databar Limited = Disable
Databar Limited = Enable
DEFAULT
035400(CR)
035401(CR)
To Next Page
Loading...
