Datalogic MAGELLAN 900i - Databar Limited Minimum Read

ENTER/EXIT PROGRAMMING MODE
158 MAGELLAN™ 900I
DataBar Limited Minimum Read
This feature specifies the minimum number of consecutive Databar Limited decodes before
is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Databar Limited Minimum Read = 1
Databar Limited Minimum Read = 2
Databar Limited Minimum Read = 3
Databar Limited Minimum Read = 4
DEFAULT
035501(CR)
035502(CR)
035503(CR)
035504(CR)