Datalogic MAGELLAN 900i - Databar Limited EAN128 Emulation Enable

ENTER/EXIT PROGRAMMING MODE
160 MAGELLAN™ 900I
DataBar Limited EAN128 Emulation Enable
Enables/disables GS1-EAN128 emulation for GS1 Databar Limited.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Databar Limited EAN128 Emulation = disable
Databar Limited EAN128 Emulation = enable
DEFAULT
036300(CR)
036301(CR)