DATABAR EXPANDED ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
163
DataBar Expanded 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Expanded barcode
with a 2D component associated with it, and the 2D component will be discarded.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
DataBar Expanded 2D Component = Disable
DataBar Expanded 2D Component = Enable
DEFAULT
04D700(CR)
04D701(CR)
To Next Page
Loading...
