Datalogic MAGELLAN 900i - Databar Expanded Minimum Read

ENTER/EXIT PROGRAMMING MODE
164 MAGELLAN™ 900I
DataBar Expanded Minimum Read
This feature specifies the minimum number of consecutive DataBar Expanded decodes
before is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
DataBar Expanded Minimum Read = 1
DataBar Expanded Minimum Read = 2
DataBar Expanded Minimum Read = 3
DataBar Expanded Minimum Read = 4
DEFAULT
04D301(CR)
04D302(CR)
04D303(CR)
04D304(CR)