DATABAR EXPANDED ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
167
DataBar Expanded Length 2
Length 2 is the maximum label length if in variable length mode, or the second fixed length
if in fixed length mode. Length includes the barcode's data characters only.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set DataBar Expanded Length 2 on page 167 below. You’ll need to
cover any unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre-
sent the desired label length. The selectable range for this option is 00 to 74. Pad all
single digit numbers with a leading zero to yield a two-digit entry (00-74).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
When in Fixed Length mode, if Length 2 is set to the value of 00
(zero), then only Length 1 will apply.
Set DataBar Expanded Length 2
Default setting for this feature = 4A (length = 74)
04BF(CR)
DEFAULT
To Next Page
Loading...
